Avaya MCC1 Maintenance Procedures page 78

Access and login procedures
Login methods
P330-1(super)#> set interface help
you will be given a much more restricted list of command possibilities that address the possible
interfaces to be set.
For a complete list of command line interface commands, type help or refer to the Avaya P330 Manager
User Guide.
LAN connection
Use this procedure to log in to the Layer 2 Switching Processor when you have a connection to the
customer's LAN.
To log in to the Layer 2 Switching Processor with a LAN connection
1 With a connection to the customer's LAN (either remotely or on site), telnet to the P330 stack
processor IP address:
Type telnet <xxx.xxx.xxx.xxx> , where <xxx.xxx.xxx.xxx> is the IP address of
the P330 stack master processor on the customer's LAN.
2 Login at the Welcome to Avaya P330 screen.
Login: xxx from the planning documentation
Password: xxx from the planning documentation
You are now logged-in at the Supervisor level. The prompt appears as P330-1(super)# .
Direct serial connection
Use this procedure to access the G700 processors when your laptop is directly connected to the S8300
Console port through a serial cable.
To access the G700 via the Console (serial) port
1 Launch Windows® HyperTerminal or any other terminal emulation program.
NOTE:
For most Windows-based PCs, you access the HyperTerminal program from the Start
menu by selecting Programs , then Accessories .
2 Choose Call - Connect (for HyperTerminal) or the appropriate call command for your terminal
emulation program.
3 Login at the Welcome to Avaya P330 screen.
Login: xxx from the planning documentation
Password: xxx from the planning documentation
You are now logged-in at the Supervisor level. The prompt appears as P330-1(super)# .
Access through Device Manager
To access the Device Manager, you must have access to the corporate LAN in which the Layer 2
Switching Processor resides.
78 Maintenance Procedures
December 2003