Avaya MCC1 Maintenance Procedures page 339

4 Slide the media server cover back from the front panel (see
removal and replacement,
front panel.
5 Lift the cover straight up and remove it from the media server.
Figure 102: Media Server cover removal and replacement
1
bkdsopen LAO051303
Figure notes
1 Hex-head bracket screws
2 Cross-point (Phillips) cover
screws
3 S8700 media server cover tabs
Remove the hard drive
1 Open the bezel on the front of the media server, if necessary, and use a #2 cross-point (Phillips)
screwdriver to unscrew the two screws on the faceplate of the hard drive bracket.
2 Partially pull out the hard drive bracket
340) so that you can disconnect the cables. Note the position of the ribbon cable within the chassis
so you can return it to exactly the same position later.
3 Unplug the 4-wire power cable from the back of the hard drive
and hard drive,
Maintenance Procedures
December 2003
on page 339) until the cover's tabs are released from the top slot of
3
4
U 1
U 2
NOTE:
The hard drive bracket is on the front right-hand side of the S8700 Media Server.
on page 340).
Figure 102, Media Server cover
3
4 Inner rail guide
5 Bottom rail of media server
(Figure 103, Hard drive bracket and hard drive,
S8700 component maintenance
2
5
1
on page
(Figure 103, Hard drive bracket
2
339