Avaya MCC1 Maintenance Procedures page 347

Table 82: Final tasks for replacing a hard drive in an S8700 Media Server
9
Task
8 Restore Configuration
on the Media Server
with the New Hard
Drive
9 Restore Data on the
Media Server with the
New Hard Drive
1 Verify the Software
0 Version.
1 (For 1.0/1.1.x
1 Replacement Only)
Reset the System
1 (For 1.0/1.1.x
2 Replacement Only)
Verify translations
1 (For R1.0/R1.1.x
3 replacement only)
Save Translations
1 (For R1.0/R1.1.x and
4 R1.2 replacements
only) Upgrade IPSI, C-
LAN, MedPro, and
VAL Circuit Pack
Firmware
1 Check the
5 Configuration
Maintenance Procedures
December 2003
Description
Get the configuration data from the customer. Alternatively, log
into the existing media server and under Server Configuration
and Upgrades click Configure Server to view the configuration
screens.
On the media server with the new hard drive, click Configure
Server to restart the configure media server process. Use the
configuration screens for the existing media server to determine
the values for the media server you are configuring. Exception:
make sure that one media server is 1 and the other is 2.
Caution: If you use the existing media server to retrieve the
configure media server data, do not click Continue at the
Update Server (Warning) screen. You do not want to
reconfigure the existing media server.
Restore translations only. Under Data Backup/Restore click
View/Restore Data.
For 1.0/1.1.x only: You must select Force restore if backup
version mismatch also for the data to be restored to a different
release of software.
Under Server Configurations and Upgrades click View
Software Version to verify that the media server with the new
hard drive is on release 1.2 or 1.3 software, as appropriate, and
has the appropriate patches.
At the SAT command prompt screen, use the reset system 4
command.
At the SAT command prompt screen, use the list station
command, and verify that the customer's stations are listed.
At the SAT command prompt screen, use the save translation
command.
The IPSI circuit packs must be on the latest firmware for an
R1.2 system. At the same time, upgrade the firmware on the C-
LAN, MedPro, and VAL circuit packs. Refer to "Upgrading the
S8700 Media Server Configuration" section of the Avaya S8300
and Avaya S8700 Media Server Library CD-ROM (555-233-
825).
CAUTION:
Upgrading the firmware on a circuit pack requires a
reset of that circuit pack.
At the SAT command prompt screen, use the list configuration
all command. Check that all the hardware is displayed.
S8700 component maintenance
(2 of 5)
347