Avaya MCC1 Maintenance Procedures page 348

S8700 component maintenance
Table 82: Final tasks for replacing a hard drive in an S8700 Media Server
9
Task
1 Stop Communication
6 Manager and Busy Out
the Media Server
1 Restart Communication
7 Manager on the Media
Server
1 Verify Busied Out
8 Status
1 Reattach All Cables
9
2 Check the Status of the
0 Standby Media Server
from the Active Media
Server
2 Check the Status of the
1 Active Media Server
from the Standby
Media Server
2 Ping the Connections
2 on the Media Server
with the New Hard
Drive
2 Check Alarms on Both
3 Media Server
2 Check the Health of the
4 Active Media Server
2 Release the Busied Out
5 Standby Media Server
2 Monitor the Refresh of
6 the Standby Media
Server
348
Description
At the Linux command line, type stop -acf.
On the Maintenance Web Interface, under Server click Busy
Out Server to busy out the media server.
At the Linux command line, type start -ac to bring the media
server up in the busied out, standby mode.
On the Maintenance Web Interface under Server click View
Summary Status. Make sure the media server is busied out.
Connect the fiber duplication cable and the Ethernet duplication
cable to the media server with the new hard drive. Connect all
the other cables.
Connect to the active media server. Click View Summary
Status. Make sure that the active media server shows data for
the standby media server.
Connect to the standby media server. Click View Summary
Status. Make sure that the standby media server shows data for
the active media server and that the data from both media
servers matches.
Under Diagnostics click Execute Pingall. Ensure that all
connections, including the active media server, the IPSI boards,
and all administered connections respond.
Under Alarms and Notification click View Current Alarms.
Clear any alarms that appear.
Connect to the active media server. On the SAT command
prompt screen, use the display alarms command. Clear any
alarms that appear.
Caution: If you cannot clear alarms, stop. Call your service
support group. Do not continue with this task list until alarms
have been resolved.
At the SAT command prompt screen, use the list ipserver-
interface and the status health commands. Check that all
connections are working correctly.
Connect to the standby media server. Under Server click
Release Server to release the media server from busy out
mode. The active media server will begin to refresh the
translations and security files of the standby media server.
Connect to the active media server. Under Server click View
Summary Status to monitor the refresh of the standby media
server until the refresh is complete.
(3 of 5)
Maintenance Procedures
December 2003