Avaya MCC1 Maintenance Procedures page 402

Additional maintenance procedures
Automatic Transmission Measurement System
Measurement data gathered by analog testcalls can be retrieved with the list testcalls command as
described in ATMS reports on page
type of test that is specified and the capabilities of the far-end TTL.
Figure 120, Test results for test analog-testcall trunk 60,
analog-testcall trunk 60
Figure 120: Test results for test analog-testcall trunk 60
test analog-testcall trunk 60
Port
02B1901
02B1902
02B1903
02B1904
02B1905
02B1906
Output fields
Field
Port
Maintenance Name
Alt. Name
Test Number
Result
Error Code
402
403. The measurements that are made and recorded depend on the
.
TEST RESULTS
Maintenance Name Alt. Name
TIE-TRK 060/001
TIE-TRK 060/002
TIE-TRK 060/003
TIE-TRK 060/004
TIE-TRK 060/005
TIE-TRK 060/006
Description
The physical location of the port supporting the trunk being
tested.
The name of the maintenance object tested, TIE-TRK or CO-
TRK.
The trunk-group number and member number of the trunk
being tested.
ATMS tests are numbered 844 through 848.
• If the test call successfully completes, and if every
trunk tests within administered thresholds for
marginal and unacceptable performance, then a PASS
result is returned.
• If measurements fall outside the thresholds, the test
fails. The trunks group can be administered to log
errors and alarms, and to busy out the failed trunk.
• If the test call cannot be completed, an ABORT is
returned.
This numerical code indicates the reason for a failure or
abort. The codes are explained in the CO-TRK and TIE-TRK
sections of ABRI-PORT (ASAI ISDN-BRI Port)
Maintenance Alarms Reference (555-245-102).
on page 402 shows a typical result for
Test No. Result Error Code
845 PASS
845 PASS
845 PASS
845 ABORT 1004
845 PASS
845 ABORT 1004
in
Maintenance Procedures
test
December 2003