Avaya MCC1 Maintenance Procedures page 340

S8700 component maintenance
4 Unplug the ribbon cable from the back of the hard drive
drive, on page 340). Note that the red stripe on the ribbon cable is on the side closest to the power
cable.
5 Pull the hard drive bracket from the media server, and place the hard drive and bracket assembly
on your antistatic mat.
Figure 103: Hard drive bracket and hard drive
1
1
Figure notes
1 Faceplate screw
2 1/8 to 1/4 inch gap
3 Hard drive
4 Bracket screws
Replace the cover on the failed S8700 Media Server
1 Replace the cover onto the media server
replacement,
bottom rails of the media server.
2 Slide the media server cover forward so that the covers' tabs slide into place under the top slots of
the front panel.
3 Screw the two cross-point (Phillips) screws into the back of the media server to hold the cover in
place (Figure 102, Media Server cover removal and replacement,
4 Reattach the brackets to the side with the hex-head screws.
340
NOTE:
There is no need to remove the hard drive from the bracket.
4
2
4
on page 339). Be sure the guides on the inner sides of the cover set correctly on the
(Figure 103, Hard drive bracket and hard
I
5 Power cable
6 Ribbon cable
7 Position of red stripe
(Figure 102, Media Server cover removal and
4
P4
3
6
4
drdsdrtp LAO041503
on page 339).
Maintenance Procedures
December 2003
5
7