Fan Assembly Removal/Replacement; Replacing The S8100 Hard Disk - Avaya MCC1 Maintenance Procedures

Component replacement
S8100 component maintenance
Figure 81: Fan/filter removal

Fan assembly removal/replacement

1 Pull (unplug) the fan assembly from the chassis. The power for the fan automatically disconnects
when the assembly is unplugged.
2 Plug in the new fan assembly. The power for the fan automatically connects when the fan
assembly is plugged in.
3 Replace the fan/filter access panel and the left door.

Replacing the S8100 hard disk

NOTE:
When the TN2314 hard disk is replaced, the system remains in License-Normal mode,
because the serial number of the processor remains the same. However, a copy of the
License and Authentication files must be obtained from RFA. Refer to
License and Authentication files
Sections in this procedure include:
• Shutdown AUDIX
• Save translations
• Backup the S8100
• System shutdown
282
scdmfltr RPY 072297
on page 91 for more information.
on page 283
on page 283
on page 283
on page 284
Filter
Fan
Downloading the
Maintenance Procedures
December 2003