Avaya MCC1 Maintenance Procedures page 179

Figure 29: Screen output for list atm pnc command
list atm pnc
PNC
Connection #
1
2
You can also use list configuration UUC (non-control cabinets) to confirm the PN's board
locations and correct insertion.
2 Enter status pnc at the S8700 Multi-Connect SAT. This screen tells you which TN230X board is
active in a duplicated system and how many alarms (if any) of each severity level have been
logged for the board.
output from status pnc.
Figure 30: Screen output for status pnc command
status pnc
State of Health:
Inter PN Index:
Major Alarms:
Minor Alarms:
Warning Alarms:
3 Enter either list configuration UUC (for the carrier where the ATM-EI packs reside) or display
circuit-packs cabinet (non-control cabinet) at the S8700 SAT. This command tells you in more
detail what boards are in which slots in each cabinet and carrier. Verify that the TN230Xs are
physically located in the slots indicated on the display.
circuit-packs 1,
output for display circuit-packs 2,
Maintenance Procedures
December 2003
ATM PNC
A-PNC
LOC
01B02
02A01
Figure 30, Screen output for status pnc command,
PORT-NETWORK CONNECTIVITY
Duplicated? no
Software Locked?
Standby Busied?
Standby Refreshed?
Interchange Disabled?
A-PNC
Mode: active
0
0
0
on page 180 shows the output for display circuit-packs 1.
on page 180 shows the output for display circuit-packs 2.
Troubleshooting ATM
Page
B-PNC
LOC
on page 179 shows the
B-PNC
Mode:
State of Health:
Inter PN Index:
Major Alarms:
Minor Alarms:
Warning Alarms:
Figure 31, Screen output for display
Figure 32, Screen
Troubleshooting
1 SPE A
179