Avaya MCC1 Maintenance Procedures page 183

Figure 37: Screen output for the show signaling summary command
A500:show signaling summary
Port
------
A1.1
A1.2
a If an A500 port with an attached S8700 Multi-Connect PN is not listed in this display, it is
likely that the port was administered incorrectly as having no UNI signaling (admin link
command).
Ensure that fields listed have the following values.
2 If the A500 was administered using hard-coded PNNI routes to identify each endpoint, enter
show signaling routes on the A500 console.
Figure 38, Screen output from the show signaling routes command,
output from the command.
Figure 38: Screen output from the show signaling routes command
A500:show signaling routes
Number of Local Static Routes Allowed:
Current number of Local Static Routes:
Address:
mask:152
Address:
mask:152
Check that the Address field (administered using the admin signaling route add command)
matches those administered in S8700 Multi-Connect.
Maintenance Procedures
December 2003
loc VCI SAP IntType
------- --- -------
1 1 Network
2 2 Network
Field Value
IntType Network
If it is User, links will not come up between the PNs.
Signaling UNI3.1
If it is UNI3.0, links will not come up between the PNs.
ILMI Preferred value of is No, however this alone does not
prevent links from coming up between the PNs.
SAP State May or may not be UP. Their values depend on more
than just whether the port was marked as UP. (See
highlighted data for SAP State in
output for the show signaling summary command,
page 183.)
47.00.05.80.ff.e1.00.00.00.f2.07.2a.01.00.00.00.00.00.00.00
cost: 0 node:self
47.00.05.80.ff.e1.00.00.00.f2.07.1b.02.00.00.00.00.00.00.00
cost: 0 node:self
Signaling ILMI SAP State
----------- ---- ------------
UNI3.1 No UP
UNI3.1 No UP
30
2
port:A1.2 state:UP
port:A1.1 state:UP
Troubleshooting
Troubleshooting ATM
State
-----
UP
UP
Figure 37, Screen
on
on page 183 shows the screen
183