Avaya MCC1 Maintenance Procedures page 349

Table 82: Final tasks for replacing a hard drive in an S8700 Media Server
9
Task
2 Save Translations on
7 the Active Media
Server
2 Log in Again to the
8 Standby Media Server
Web Interface
2 (For R1.0/R1.1.x
9 replacement only)
Make the Standby
Media Server the
Active Media Server
3 (For R1.0/R1.1.x
0 replacement only)
Check the Status of the
Active Media Server
3 (For R1.0/R1.1.x
1 replacement only)
Resolve Alarms on
Both Media Servers
3 (For R1.0/R1.1.x
2 replacement only) Log
into the Existing Media
Server
3 (For R1.0/R1.1.x
3 replacement only)
Upgrade the Existing
Media Server
3 (For R1.0/R1.1.x
4 replacement only)
Install Software Patch
on Existing Media
Server
Maintenance Procedures
December 2003
Description
Once the media server is refreshed, on the SAT command
prompt screen, use the save translation command.
Connect to the standby media server. Open a browser on your
laptop, and using 192.11.13.6, log into the Maintenance Web
Interface. You should be ASG challenged in order to log in.
Note: You should no longer be able to use the initial installation
craft password.
(For R1.2 and R1.3 replacements only) Go to
ID on the Replacement Media Server on page
Under Server click Interchange Servers
interchange regardless of server status to make the standby
media server the active media server.
Note: This forces a reset system 4. Monitor the media server to
make sure it is healthy before continuing.
At the SAT command prompt screen, use the list trunks, list
stations, list hunt, and list data commands to make sure that
the same items that were in service before the replacement are
still in service.
On the active media server first, click View Current Alarms.
Then resolve alarms. Connect to the standby media server and
resolve alarms on the standby media server.
On the SAT command prompt screen, use the display alarms
command.
Connect to the Services port on the back of the media server that
did not need a hard drive replacement and using 192.11.13.6,
log into the Maintenance Web Interface
Insert the R1.2 software CD into the existing media server CD-
ROM drive. Under Server Configuration and Upgrade click
Install New Software Release and continue through the
software installation.
Note: Be sure to select Make Server Upgrade Permanent
before continuing.
Under Miscellaneous click Upload Files to Server (via
browser) to copy the patch to the /var/home/ftp directory. Refer
to Avaya S8300 & S8700 Media Server Patching Procedures
available at http://avaya.com/support.
S8700 component maintenance
Set the Product
337.
.
Also, select Force
(4 of 5)
349