5
Disconnect and label the LAN connection (if used) from the Ethernet port on the RSA.
6
Pull the server forward so that the server rails expand and the retaining clips on the rails click into
place.
7
Unplug and label the cable from the Ethernet port labeled LINK A on the dual NIC.
Removing the cover of the Media Server
1
Loosen the two captive screws on the back of the media server (see
cover's captive screws,
2
Slide the server cover back from the front panel until the cover's tabs are released from the top
slot of the front panel.
3
Lift the cover straight up and move it away from the server as shown in
server cover's captive screws,
Figure 97: Locating the server cover's captive screws
Figure notes
1
Server cover's captive screws
322
CAUTION:
Remove all power from the media server before starting this procedure.
on page 322.
on page 322.
d is
c
Figure 97, Locating the server
Figure 97, Locating the
1
h3mscaps LAO 070103
Maintenance Procedures
December 2003