Avaya MCC1 Maintenance Procedures page 335

Table 78: Final Tasks for replacing an S8700 Media Server
9
Task
10 Verify the Software Version.
11 (For 1.0/1.1.x Replacement
Only) Reset the System
12 (For 1.0/1.1.x Replacement
Only) Verify translations
13 (For R1.0/R1.1.x
replacement only) Save
Translations
14 (For R1.0/R1.1.x and R1.2
replacements only) Upgrade
IPSI, C-LAN, MedPro, and
VAL Circuit Pack Firmware
15 Check the Configuration
Stop Communication
16
Manager and Busy Out the
Media Server
17 Restart Communication
Manager on the Standby
Media Server
18 Verify Busied Out Status
19 Reattach All Cables
20 Check the Status of the
Standby Media Server from
the Active Media Server
21 Check the Status of the Active
Media Server from the
Standby Media Server
Maintenance Procedures
December 2003
Description
Under Server Configurations and Upgrades click View
Software Version to verify that the replacement media
server is on release 1.2 or 1.3 software, as appropriate,
and has the appropriate patches.
At the SAT command prompt screen, use the reset
system 4 command.
At the SAT command prompt screen, use the list station
command, and verify that the customer's stations are
listed.
On the SAT command prompt screen, use the save
translation command.
The IPSI circuit packs must be on the latest firmware for
an R1.2 system. At the same time, upgrade the firmware
on the C-LAN, MedPro, and VAL circuit packs. Refer to
"Upgrading the S8700 Media Server Configuration"
section of the Avaya S8300 and Avaya S8700 Media
Server Library CD-ROM (555-233-825).
CAUTION:
Upgrading the firmware on a circuit pack
requires a reset of that circuit pack.
On the SAT command prompt screen, use the list
configuration all command. Check that all the hardware
is displayed.
At the Linux command line, type stop -acf.
On the Maintenance Web Interface under Server, click
Busy Out Server to busy out the Media Server.
At the Linux command line, type start -ac to bring the
media server up in the busied out, standby mode.
Under Server click View Summary Status. Make sure
the media server is busied out.
Connect the fiber duplication cable and the Ethernet
duplication cable to the replacement media server.
Connect all the other cables.
Connect to the active media server. Click View
Summary Status. Make sure that the active media server
shows data for the standby media server.
Connect to the standby media server. Click View
Summary Status. Make sure that the standby media
server shows data for the active media server and that the
data from both media servers matches.
S8700 component maintenance
(3 of 5)
335