Avaya MCC1 Maintenance Procedures page 297

Hide thumbs Also See for MCC1:
Table of Contents

Advertisement

9
If necessary, upgrade the media server software on the new hardware:
a If the software release installed on the new hardware is earlier than the release on the
original hardware, upgrade the software on the new hardware to match the release on the
original hardware.
a If the software release on the original hardware is unknown, and the software on the new
hardware is not the latest bug-fix load, upgrade the software on the new hardware to the
latest bug-fix load.
10
Configure the S8300 and restore data. Do either Step a or Step b:
a If the original hardware is functional or if the software release installed on the original
hardware is the same as or later than the release installed on the new hardware, then:
b If the original hardware is not functional and the software release installed on the original
hardware is either unknown or earlier than the release installed on the new hardware,
then:
11
If the new hardware has a later software release than the original hardware, check to see if you
need to upgrade the G700 firmware as described in Step 8 in the
12
Install any software patches required.
13
Check for and resolve any new alarms.
14
Test as appropriate — for example, make station and trunk calls.
15
Save translations. If the S8300 on which you replaced the hardware is configured as an LSP, save
translations on the primary controller, not the LSP.
16
Disable FTP on the S8300:
a On the Maintenance Web Interface, select Enable/Disable Anonymous FTP under the
"Security" heading
b Click on Disable
Maintenance Procedures
December 2003
— Configure the network data (Host Name, IP address, subnet mask, default gateway
IP address).
— Restore all data
— Configure the S8300 as you would a new install using either the Avaya Installation
Wizard and the Pre-Installation Worksheet previously created, or using the
Maintenance Web Interface.
— Restore only the translations and the Audix announcements
Component replacement
S8300 and G700 component maintenance
Before you go to the site
section.
297

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scc1Cmc1G600G650G350G700

Table of Contents