Avaya MCC1 Maintenance Procedures page 313

4 Replace the adapter support bracket lining up the tabs on each side of the bracket and the screw
holes on the riser card connector.
5 Align the riser card with the connector and the tabs on the adapter support bracket with the
provided holes and press the riser card firmly into the connector.
6 Tighten the captive screw to the right of the slot.
Replacing the cover of the Media Server
1 Replace the cover onto the server.
2 Slide the cover forward so the cover's tabs slide into place under the top slots of the front panel.
3 Finger-tighten the thumb screws on the back of the server.
4 Release the retaining tabs on the rails and slide the S8500 Media Server back into place on the
data rack.
Connecting the cables to the RSA
1 Connect the external power supply (Note 2 in
304) to the RSA.
2 Connect the modem to the RS-232 port.
3 Do not plug in the LAN connection (if used). You will need to access the Ethernet port on the
RSA once power is restored.
Maintenance Procedures
December 2003
NOTE:
Route the ribbon cable so that it does not block the flow of air from the fans.
NOTE:
Do not apply power to the media server yet.
Figure 85, RSA faceplate and connectors, on page
313