Avaya MCC1 Maintenance Procedures page 411

The results from the above command are shown in
Table 100: TEST RESULTS
Port
001V4
Command successfully completed
If a secondary is similarly provisioned:
Table 101: mgp-001-1(configure)# set sync interface secondary v3
mgp-001-1(configure)# show sync timing
SOURCE
Primary
Secondary
Local
To activate the secondary, the following is similarly done:
Table 102: mgp-001-1(configure)# set sync source secondary
mgp-001-1(configure)# show sync timing
Source
Primary
Secondary
Local
Note: The system uses one clock at a time only: therefore only the secondary is active and the
primary is locked out.
To activate local the following is done:
Table 103: mgp-001-1(configure)# set sync source local
mgp-001-1(configure)# show sync timing
Source
Primary
Secondary
Local
Maintenance Procedures
December 2003
Maintenance
Name Alt. Name
MG-DS1 144
MM
V4
V3
V0
MM
V4
V3
V0
MM
V4
V3
V0
Additional maintenance procedures
Setting G700 synchronization
Table 100:
Test No.
Result
PASS
STATUS FAILURE
Active None
Standby None
Standby None
Status Failure
Locked Out None
Active None
Standby None
Status Failure
Locked Out None
Locked Out None
Active None
Error Code
411