Omron K6PM-TH User Manual page 96

4 Monitoring the Temperature in Control Panel with the Main Unit and the Software Tool
Measurement value,
alarm result
Automatic*
Read at specified sampling cycle
K6PM-TH
Description
The following log file and folder are created in the PC.
 Log File Save Location
Folder name: "(Installation-destination folder)\log\[Main Unit number (2 digits)]"
Example: "\Program files\OMRON\Thermal Condition Monitoring Tool\log\01"
Note If there is no folder when the software tool is started, the folder is automatically created.
Additional Information
You can also check this by clicking the Log folder Button on the Device List of K6PM Screen.
 Save Timing
• In each sampling cycle
• When you exit the Device List of K6PM Screen by clicking the × Button at the top right of the
Device List of K6PM Screen
 Specifications of Log File
• File unit
A file is created for each Main Unit name.
• File name
Specify the Main Unit number and date in the file name.
The format of the file name is as described below.
Folder name_YYYYMMDDHHMMSS.txt
"YYYYMMDDHHMMSS" is the sampling time when writing is first started.
YYYY: Year, MM: Month, DD: Date, HH: Hour, MM: Minutes, SS: Seconds
• If the Main Unit name is changed on the software tool, the header information (described
later) in the file will change. Therefore, create the next new log file, and record the measure-
ment data in this log file.
• A new log file is created after every 1,440 rows (excluding the header) regardless of the sam-
pling interval.
4 - 20
Software tool
Current
value
1
Logging
At the end of the project
TXT file
*1: Always, as long as the software tool is operating
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
and the corresponding Main Unit is in the monitor-
ing mode.