Omron K6PM-TH User Manual page 87

4 Monitoring the Temperature in Control Panel with the Main Unit and the Software Tool
Sym-
Name
bol
Threshold set-
D
ting mode
E Color scale
F Back Button
*1. In the following cases, the alarm occurrence state is not displayed.
• When the measured value is less than threshold 1 or threshold 2 by the amount of hysteresis
(3°C/5.4°F)
• When the alarm latch is enabled and the measured value is less than threshold 1 or threshold 2
*2. The result of comparison of the set threshold to current temperature is displayed.
Alarm hysteresis and alarm latch are not applied.
• When a communications error occurs
When a communications error occurs while the software tool is communicating with the target Main
Unit during the display of the Monitoring sensor Screen, the following dialog box will be displayed.
At this time, the thermal image display part turns gray. Only the Back Button is enabled.
• When registration is canceled
If the target Main Unit moves to the sensor search mode during monitoring, the following message
box will be displayed.
If you click the OK Button, the display will return to the Device List of K6PM Screen.
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
Set the alarm threshold value (threshold 1 and threshold 2) of each segment.
Refer to 4-3 Alarm Threshold Setting on page 4-23 for details.
The display color scale can be adjusted.
Adjust the color scale in accordance with the temperature difference.
Click the Auto-range Button to perform automatic adjustment.
Use this button to close this screen and return to the Monitoring K6PM
Screen.
Description
4
4 - 11