Omron K6PM-TH User Manual page 187

4
EtherNet/IP Connection Settings
After creating the network variables (input), perform setting the EtherNet/IP connection for Eth-
erNet/IP tag data link communications.
(1) Opening the EtherNet/IP Device List Tab Page
Select Tool (T) | EtherNet/IP Connection Settings (N) on the menu bar.
(2) Opening the EtherNet/IP Connection Settings (Tag Set Display)
Select the EtherNet/IP originator device and double-click it, or right-click the originator
device and select Edit (E). (If you use the built-in EtherNet/IP port, only the built-in Ether-
Net/IP port is displayed as an originator device. In that case select it, highlight it and then
operate it.)
(3) Registering the K6PM Devices to the Network
Make the following settings so that the K6PM device operates as a target.
(3)-1 Installing EDS Files
To configure K6PM as an EtherNet/IP tag data link communications target, install the EDS
file containing the configuration information of the K6PM in the SysmacStudio. Once this
installation is done, this operation is unnecessary from the next setting.
This operation is unnecessary because it is preinstalled if you use the SysmacStudio
Ver.1.21 or higher.
You can download the EDS file from our website.
Register the CIP revision that corresponds to the EIP version indicated on the side label of
the Main Unit.
To check the CIP revision, refer to the label on the side of the Main Unit (page A-14).
Right-click anywhere in the Target Device List in the Toolbox on the right of the EtherNet/IP
Connection Setting Tab Page and select Display EDS Library from the menu.
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
Appendices
A
A - 31