Omron K6PM-TH User Manual page 32

1 Outline
When the Sensor Configuration Has Not Been Registered ("K6PM-TH
Sensor Search Mode", or "K6PM-TH Sensor Position Adjustment
Mode")
After turning on the power or a software reset, you can check the status of communications with infra-
red thermal sensors on the front panel of the Main Unit.
 Changing K6PM-TH Sensor Numbers in Succession
Press the CH Key and successively change the K6PM-TH sensor numbers.
When the power supply
is turned ON or the
software reset is done.
All lit
*1
*1. After turning on the power or a software reset, up to 30 seconds is required to calculate all temperature data.
*2. "on" is displayed for a sensor that sends a response, and "off" is displayed for a sensor that sends no
response.
*3. Example: If you select sensor 2 and display the Setting sensor screen in the software tool, "adj" will appear.
When the Sensor Configuration Has Already Been Registered
("Monitoring Mode")
After the sensor configuration has been registered by using the software tool or communications, the
operation flow is as described below. After turning on the power or a software reset, the Main Unit
enters monitoring mode. The measurement/monitor status can be checked on the front of the Main
Unit.
 Changing K6PM-TH Sensor Numbers In Succession
To change K6PM-TH sensor numbers in succession, press the CH Key.
 Check Segment Values of a Sensor
To change segment numbers in succession, press the SEG / ALM RST Key.
The segment numbers change in order from "0" to "15". "99" appears next, indicating sensor internal
temperature.
1 - 14
K6PM-TH sensor search mode
Press CH Key
Number of currently-connected sensors
on or off *2
K6PM-TH sensor number
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
Press CH Key
Press CH Key
Position adjustment mode
Switch to the
Setting sensor
screen with the
*3
software tool