Omron K6PM-TH User Manual page 7

Electrical shock may cause minor injury. Do not touch the product except for the front-panel but-
tons while electricity is being supplied.
Electric shock may occasionally occur. Be sure to turn OFF the power supply before connecting
the sensor.
There is a risk of minor electrical shock, fire, or device failure. Do not allow any pieces of metal,
conductors, or cutting chips that occur during the installation process to enter the product.
Explosions may cause minor injuries. Do not use the product in locations with inflammable or
explosive gases.
There is a risk of minor electrical shock, fire, or device failure. Never disassemble, modify or
repair the product or touch any of the internal parts.
Incorrect wiring the input and output may occasionally result in fire and may occasionally occur
resulting in property damage to connected equipment and machinery. Wire the input and output
terminals correctly before power is supplied.
If installation of wiring material is shallow, material damage due to ignition may occur in rare
cases. When wiring, be sure to insert the wiring material all the way in.
Conformance to Safety Standards
• Reinforced insulation is provided between input power supply, output, and between other ter-
minals (Main Unit only).
• If the equipment is used in a manner not specified by the manufacturer, the protection pro-
vided by the equipment may be impaired.
• K6PM-TH must be installed within a control panel as an embedded device, if using as a UL
certified product.
• Be sure to use the recommended fuse specified in the instruction manual by mounting it on
the power supply input terminal of the Main Unit (+) or the power supply input terminal of the
sensor (+V).
Conformance to EN/IEC Standards
This is a class A product. This is a class A product. In residential areas it may cause radio inter-
ference, in which case the user may be required to take adequate measures to reduce interfer-
ence.
To comply with EN standards, use an EN standard-compatible switching power supply for sup-
plying the power supply voltage to the K6PM. Also, use a shielded cable between the sensor
and the Main Unit, and between two sensors.
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
CAUTION
Safety Precautions
5