Omron K6PM-TH User Manual page 193

General
Status Status Name
(hex)
12 Fragmentation of a
primitive value
13 Not enough data
14 Attribute not supported The attribute specified in the request is not supported.
15 Too much data
16 Object does not exist
17 Service fragmentation
sequence not in prog-
ress
18 No stored attribute
data
19 Store operation failure
1A Routing failure
(request packet too
large)
1B Routing failure
(response packet too
large)
1C Missing attribute list
entry data
1D Invalid attribute value
list
1E Embedded service
error
20 Invalid parameter
21 Write-once value or
medium already writ-
ten
22 Invalid Reply Received An invalid reply is received (For example, the reply service code does not
23-24
25 Key Failure in path
26 Path Size Invalid
27 Unexpected attribute
in list
28 Invalid Member ID
29 Member not settable
2B-CF
D0-FF Reserved for Object
Class and service
errors
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
Description of Status
The service specified an operation that is going to fragment a primitive data
value, i.e. half a REAL data type.
The service did not supply enough data to perform the specified operation.
The service supplied more data than was expected.
The object specified does not exist in the device.
The fragmentation sequence for this service is not currently active for this
data.
The attribute data of this object was not saved prior to the requested ser-
vice.
The attribute data of this object was not saved due to a failure during the
attempt.
The service request packet was too large for transmission on a network in
the path to the destination. The routing device was forced to abort the ser-
vice.
The service response packet was too large for transmission on a network in
the path from the destination. The routing device was forced to abort the
service.
The service did not supply an attribute in a list of attributes that was needed
by the service to perform the requested behavior.
The service is returning the list of attributes supplied with status information
for those attributes that were invalid.
An embedded service resulted in an error.
A parameter associated with the request was invalid. This code is used
when a parameter does not meet the requirements of this specification
and/or the requirements defined in an Application Object Specification.
An attempt was made to write to a write-once medium (e.g. WORM drive,
PROM) that has already been written, or to modify a value that cannot be
changed once established.
match the request service code, or the reply message is shorter than the
minimum expected reply size.) This status code can serve for other causes
of invalid replies.
Reserved by CIP for future extensions.
The Key Segment that was included as the first segment in the path does
not match the destination module. The object specific status shall indicate
which part of the key check failed.
The size of the path which was sent with the Service Request is either not
large enough to allow the Request to be routed to an object or too much
routing data was included.
An attempt was made to set an attribute that is not able to be set at this
time.
The Member ID specified in the request does not exist in the specified
Class/Instance/Attribute.
A request to modify a non-modifiable member was received.
Reserved by CIP for future extensions.
This range of error codes is to be used to indicate Object Class specific
errors. Use of this range should only be performed when none of the Error
Codes presented in this table accurately reflect the error that was encoun-
tered. The additional code field is used to describe the general error code in
more detail.
Appendices
A
A - 37