Omron K6PM-TH User Manual page 164

Appendices
Infrared Thermal Sensor Characteristics
Item
Temperature
measurement
Other functions
Output
Applicable
standards
Recommended fuse
Insulation resistance
Dielectric strength
Vibration resistance
Shock resistance
Degree of protection
Indicators
*1. Accuracy may vary depending on the measured distance, the object's emissivity, and ambient temperature.
*2. Accuracy for the central four segments when the measured object is 25°C to 80°C. If a high temperature object
is measured with the outer 12 segments, the accuracy may decrease due to area effect.
*3. Performance of central four segments. ±2°C for the outer 12 segments.
*4. Make ON/OFF settings on the DIP switch Pin 2 (default value: OFF). For details, refer to DIP Switch Settings
on page 1-17.
*5. Since the operation is not stable at a location subject to vibrations, it may not be possible to detect angle de-
viation.
*6. During screw mounting
A - 8
Model
Temperature mea- Temperature measurement range: 0.0°C to 200.0°C (32.0°F to 392.0°F)
surement range
Detection resolu- 32 × 32 (1,024 pixels)
tion
Temperature accu-
±5°C (at an ambient temperature of 25°C)
racy
Emissivity 0.94
Reproducibility
±1°C (at an ambient temperature of 25°C)
Temperature drift 0.15°C
Warm up time 15 minutes
Viewing angle 90° × 90°
[FOV]
Temperature mea- Outputs K6PM-TH sensor error in following condition
surement range
Temperature: 200.0°C or higher
exceeded
Sensor internal temperature: 80°C or higher
Angle deviation
Detection of only angle deviation
*4
detection
Angle deviations of 5° (typ) min. and those that continue for 3 seconds
min. can be detected.
Communications RS-485 communications
method
Maximum cable 500 m
length
Approved stan- UL61010-1 (listing) installation location: Pollution degree 2
dards
Korean Radio Waves Act
Conforming stan- RCM
dards
EMC EN61326-1 (EMI: Class A EMS: Industrial Location), Measured tempera-
ture fluctuation range: ±6°C
T2A, time lag, shut-off capacity
20 MΩ min.
Between all terminals and the case
1,000 VAC for 1 minute
Between all terminals and the case
Frequency: 10 to 55 Hz, 0.35-mm single amplitude in X, Y, and Z direc-
tions (10 sweeps of 5 min each)
150 m/s
IP20
Power indicator Green (when power is on: Lit, when power is not on: Not lit)
Communications Orange (when communications are performed: Lit, when communica-
indicator tions are not performed: Not lit)
Alarm indicator Red (when a sensor error occurs: Lit, when an angle deviation is
detected: Flashing)
K6PM-THS3232
*5
*6
2
, 3 times each in 6 directions along 3 axes
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
*1*2
*3
*6