Omron K6PM-TH User Manual page 72

3 Initial Setting
Symbol
E Position registration
Button
F Photograph reading
Button
G Back Button
*1. Photo images must be captured by the customer.
3
Hold up the heat-generating device in the area to be measured, and perform position adjust-
ment while checking the thermal image on this screen.
Note To display the photo image of the measurement location, click the Photograph reading Button on the
Setting sensor screen to select the photograph of the measurement location.
4
After ending position adjustment, click the Position registration Button. The current sensor
position is registered in the Main Unit.
5
Click the Back Button to return to the Setting K6PM screen, and register the position of the
other sensors in a similar manner.
If an angle deviation occurs in the infrared thermal sensor while the Setting K6PM screen shown below
is being displayed, the
In such a case, click the Details Button, and after adjusting the position again on the Setting sensor
screen, click the Position registration Button.
3 - 16
Name
Register the correct position of the infrared thermal sensor based on the
current position.
Select the photo image of the measurement location, and paste it.
To read the photo image showing the measurement target, start Explorer.
When file selection is complete, copy the image under the "cfg\image"
folder.
Use this button to close this screen and return to the Setting K6PM screen.
icon will be displayed in the position setting column.
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
Description
If an angle deviation has
occurred, the
be displayed.
*1
icon will