Omron K6PM-TH User Manual page 189

(3)-2 Adding K6PM Devices to the Network
Click the
nection Setting Tab Page.
As shown in the following example, enter the node address (IP address), and from the
pull-down list, select the model and revision.
Click the Add Button at the bottom of the toolbox. The K6PM device will be added as a tar-
get device.
(4) Editing tag set
Map the K6PM Input data to the memory area of the PLC using the EtherNet/IP tag data
link by associating the network variable (input) of the PLC with the tag used in the network.
As a method of editing the tag set, there is a method of registering all tag sets, and a
method of individual registering by right-clicking and selecting Create New Tag Set. Here,
the method of registering is described.
(4)-1 Open Tag Set Registration Setting Dialog Box
Click the Registration All Button in the Tag Set Pane, a list of network-published global
variables will be displayed. In this example, only "K6PM_THM_Monitor_Data1" to
"K6PM_THM_Monitor_Data4" which was registered as a network variable (input) is dis-
played.
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
(Add Target Device) Button in the Toolbox on the right of the EtherNet/IP Con-
Click Click Click
Appendices
A
A - 33