Removing Wires from the Push-In Plus Terminal Block
Use the following procedure to remove wires from the terminal block.
The same method is used to remove stranded wires, solid wires, and ferrules.
1
Hold a flat-blade screwdriver at an angle and insert it into the release hole.
2
With the flat-blade screwdriver still inserted into the release hole, remove the wire from the ter-
minal insertion hole.
3
Remove the flat-blade screwdriver from the release hole.
<Upper side>
K6PM-TH Thermal Condition Monitoring Device User's Manual (H231)
(2)
Wire
(3)
(1)
Flat-blade screwdriver
10 to 15°
Flat-blade screwdriver
2 Installation and Wiring
<Lower side>
Flat-blade screwdriver
(3)
(1)
Wire
(2)
Flat-blade screwdriver
10 to 15°
2
2 - 13