Table of Contents
Advertisement
Chapter 1, Getting Started
Obtaining Measurement Results
Obtaining Measurement Results
Setting Up a Call
To obtain CDMA measurements, the Test Set must have the MSUT (Mobile
Station Under Test) on a call (the Connected annunciator on the CDMA CALL
CONTROL screen is lit when the MSUT is on a call).
The procedure for setting up a call is provided in "Setting Up a Call", found in the
Agilent Technologies E8285A Application Guide. In the Agilent E8285A
Application Guide, there are also procedures for performing CDMA tests.
Triggering and Displaying Measurements
When operated over the front panel (local control), Test Set measurement results
are obtained by selecting a screen that displays the desired measurement, arming
the measurement if necessary, and observing the displayed value.
When operated remotely, measurement results are obtained via GPIB by
triggering a measurement if necessary and querying the desired measurement
field.
NOTE:
In CDMA mode, transmitter (TX) measurements and receiver (RX) measurements can run
concurrently. For example, an Average Power or Channel Power measurement can be queried
while the RX TEST screen is selected and an FER measurement is running.
For a detailed description of triggering measurements, see
Triggering Process" on page 73
28
S:\agilent\e8285\USRGUIDE\BOOK\CHAPTERS\getstart.fb
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
.
"Measurement
Advertisement
Table of Contents
