Table of Contents
Advertisement
Chapter 4, Status Reporting
GPIB Status Register Groups
Serial 2 Status Register Group
The Serial 2 Status Register Group contains information about SBRC (Serial Bus
Receiver Chip) communication errors which occur either at power up or when an
GPIB *TST? command is issued.
The Status Byte Register summary message associated with the Serial 2 Status
Register Group is bit zero. The Serial 2 Status Register Group SMB in the
Communicate Status Register Group and the Communicate Status Register Group
SMB in the Hardware 1 Status Register Group must be enabled before any of the
following events or conditions can be reported through the Status Byte Register.
Figure 30 on page 201
Status Register Group.
Table 15
assignments.
200
S:\agilent\e8285\USRGUIDE\BOOK\CHAPTERS\hpibstat.fb
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
shows the structure and STATus commands for the Serial 2
shows the Serial 2 Status Register Group Condition Register bit
Advertisement
Table of Contents
