Table of Contents
Advertisement
Chapter 6, IBASIC Controller
Interfacing to the IBASIC Controller using Serial Ports
Terminal Configuration
Terminals typically have a DB-25 (male) connector. Set the terminal for DEC VT-
100 ANSI emulation. Many ASCII terminals will also function properly.
To set up the terminal, use the field settings found in the Agilent Technologies
AdvanceLink terminal emulator section found earlier in this chapter. As a
minimum, make sure the terminal's basic setup information matches the fields on
the Test Set's I/O CONFIGURE screen (refer to
recommended settings).
286
S:\agilent\e8285\USRGUIDE\BOOK\CHAPTERS\ibasic.fb
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
for
table 33 on page 278
Advertisement
Table of Contents
