Table of Contents
Advertisement
Table 13
Hardware 1 Status Register Group Bit Assignments
Is Condition
Bit
Register
Number
Implemented?
15
14
NO
NO
12
YES
11
YES
10
YES
9
YES
8
YES
7
YES
6
YES
5
NO
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Condition/Event
Unused in the Test Set
Radio Interface Board
interrupt 2 tripped
Radio Interface Board
interrupt 1 tripped
Signaling Decoder
Measurement Results
Available
Signaling Decoder Input Level
Too Low
Signaling Decoder is
Measuring
Signaling Decoder is Armed
Signaling Encoder Sending
Auxiliary Information
Signaling Encoder Sending
Information
Communicate Status Register
Group SMB
Measurement Limits exceeded
Chapter 4, Status Reporting
GPIB Status Register Groups
Comment
Defined by SCPI Version 1994.0
Not used. Hardware not present in the
E8285.
Not used. Hardware not present in the
E8285.
If the Signaling Mode selected has two
information fields, such as the AMPS Filler
and Message fields, and both fields are
being sent, this bit will be set.
If the Signaling Mode selected has only one
information field and the field is being sent,
this bit will be set high. If the Signaling
Mode selected has two information fields,
such as the AMPS Filler and Message
fields, and only one field is being sent, this
bit will be set high.This bit is not active if
the Signaling Encoder Mode is set to
Function Generator
This bit is set high if the measurement's
high or low limit is exceeded
159
Advertisement
Table of Contents
