Agilent Technologies E8285A User Manual page 64

Cdma mobile station test set
Hide thumbs Also See for E8285A:
Table of Contents

Advertisement

To Remove (Clear) an Individual SAVE Register
1. Specify where the register is stored using the Save/Recall field on the I/O CON-
2. Press the Recall key.
3. Use the knob to position the cursor in front of the register to be removed from the Re-
4. Press the Yes On/Off key. A prompt appears, asking if you want to delete the save reg-
5. Press the Yes On/Off key to select YES. (Press the RATIO W key to select NO.)
GPIB Example
The following GPIB command clears a register
"REG:CLE '<quoted string>'"
Choosing Register Names
You can use any number, letter, or combination of numbers and letters as a name
for storing instrument settings. For instance; if you want to save a setup for testing
a "Vulcan7" radio, you can save the setting as "VULCAN7".
Two register names are reserved for special purposes: POWERON and BASE.
Specifying POWERON Settings
You can specify the instrument setting at power-on by following the procedure
described in
name POWERON. If a SAVE Register named POWERON is detected by the Test
Set during its power-on routine, the Test Set will configure itself using the settings
stored in the POWERON register.
NOTE:
If the Test Set does not successfully complete its power-on routine because of the POWERON
settings (e.g., the Test Set displays a message that requires you to cycle power to recover) you
must:
1. Turn off the Test Set.
2. Hold down the PRESET and the Hz/uV keys simultaneously.
3. Turn on power while holding the PRESET and the Hz/uV keys down until the CALL
This procedure will clear all SAVE registers, including POWERON.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
FIGURE screen.
call menu at the bottom right of the screen. The register name and percentage of
SAVE memory occupied by that register are indicated at the very top of the screen.
ister.
"To Save an Instrument Setup" on page 61
CONTROL screen appears.
Chapter 3, Operating Overview
Saving and Recalling Instrument Setups
, and choosing the register
63

Advertisement

Table of Contents
loading

Table of Contents