Table of Contents
Advertisement
About this Procedure
Computer System
An HP
used to develop the following procedure and program example.
Description of Procedure
The following procedure provides example commands that will generate an SRQ
Interrupt when the Connected bit, (bit 3 in the CDMA Status Register Group)
indicates that a call has been dropped.
A complete
page 229
See
information about status reporting structure and CDMA status register group bit
definitions.
Procedure Overview
For detailed step-by-step explanation see the page associated with the step.
1.
2.
3.
4.
5.
6.
7.
8.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
®
9000 Series 300 running the HP
"Example BASIC Program to Set Up and Service an SRQ Interrupt" on
is provided after the SRQ interrupt procedure is described.
"CDMA Status Register Group" on page 124
"Decide which conditions will be used to generate an SRQ interrupt." on page
"Set up the CDMA Status Register Group Transition Filters." on page
"Enable the CDMA Status Register Group SMB." on page
"Enable the Operation Status Register Group SMB." on page
"Enable SRQ Generation." on page
"Define the program branch desired when an enabled interrupt occurs." on page
226.
"Enable the Interrupt." on page
"Service the interrupt." on page
Chapter 4, Status Reporting
Setting up an SRQ Interrupt
®
BASIC programming language was
for detailed reference
223.
225.
227.
228.
220.
222.
224.
219
Advertisement
Table of Contents
