Table of Contents
Advertisement
Chapter 3, Operating Overview
To Change the Measurement Display
To Use the METER Format
The METER function displays measurements graphically. The METER format is
available for most measurements. To determine if the METER format is provided
for a measurement, position the cursor in front of the measurement's units field
and press the knob. If the message "Press ON/OFF, LIMITs, REF, AVG, METER,
or units" is displayed, the METER format is provided.
As a measurement is displayed on the meter, the value is also displayed in small
digits below the meter. You can specify the high and low end points and number
of intervals, or you can use the default meter settings.
Front-Panel Example
1. Position the cursor in front of the measurement's unit-of-measure.
2. Press and release the Shift key, then the Increment set key to select the METER func-
3. Select On/Off
4. Repeat steps 1 and 2 then select LoEnd, Hi End, or Intervals to enter each meter
5. Repeat steps 1, 2, and 3 to cancel the meter function.
GPIB Example
The following GPIB command turns on the
"DISP CCNT;MEAS:CDM:AVGP:MET ON"
50
S:\agilent\e8285\USRGUIDE\BOOK\CHAPTERS\opoverv.fb
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
tion. The default number of average samples is displayed below the measurement.
from the
Meters:
end point and the meter intervals.
field
on the CRT display
measurement's meter.
Avg Power
Advertisement
Table of Contents
