Table of Contents
Advertisement
2. Trigger the Signaling Decoder (applies if trigger mode is "Single")
Manual Operation:
1. Position the cursor at the Arm Meas field.
2. Press the knob.
Arming the Signaling Decoder as shown in this example will cause the measurement to be automati-
cally triggered by an internal trigger command.
Selecting the Stop Meas field will stop the currently executing measurement cycle for the Signaling
Decoder.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Triggering Analog Measurements In Local Mode (Front Panel Operation)
Chapter 3, Operating Overview
79
Advertisement
Table of Contents
