Table of Contents
Advertisement
Chapter 3, Operating Overview
Measurement Triggering Process
Default Trigger Modes
Default Trigger Mode for Remote Operation: CDMA and Analog Measurements
Upon powerup, or upon receiving a *RST command, or upon pressing the front
panel Preset key, the Test Set's default trigger mode for remote operation of both
CDMA and analog measurements is Repetitive
If a local-to-remote transition occurs, the trigger mode will be set to the last
trigger mode command received while in remote mode. If no trigger mode
command has been received since powerup, the default state is set.
Default Trigger Mode for Local Operation: CDMA Measurements
Upon powerup, or upon receiving a *RST command, or upon pressing the front
panel Preset key, the Test Set's default trigger mode for front panel operation of
the FER and Rho Suite of Measurements is Single retriggering.
If a remote-to-local transition occurs, the trigger mode will be determined by:
•
•
NOTE:
Setting the Meas Cntl field to Cont (Continuous) sets the trigger mode to repetitive
retriggering.
Upon powerup, or upon receiving a *RST command, or upon pressing the front
panel Preset key, or upon a remote-to-local transition the Test Set's default trigger
mode for front panel operation of the Avg/Chan Power measurement is Repetitive
retriggering.
Default Trigger Mode for Local Operation: Analog Measurements
Upon powerup, or upon receiving a *RST command, or upon pressing the front
panel Preset key, the Test Set's default trigger mode for front panel operation of
analog measurements is Repetitive
76
S:\agilent\e8285\USRGUIDE\BOOK\CHAPTERS\opoverv.fb
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
the state of the
FER -
Meas Cntl
RECEIVER TEST screen
Rho Suite of Measurements
CELLULAR MOBILE TRANSMITTER TEST screen
retriggering
field on the
CDMA CELLULAR MOBILE
the state of the
-
Meas Cntl
with Full settling.
retriggering
with Full settling.
field on the
CDMA
Advertisement
Table of Contents
