Table of Contents
Advertisement
Preparing the Test Set for GPIB Control
1. If other GPIB devices are in the system, attach an GPIB cable from the Test Set's rear-
2. Access the I/O CONFIGURE screen and perform the following steps:
NOTE:
Only one active controller is allowed on the GPIB at one time!
3. If an GPIB printer is or will be connected to the Test Set's rear-panel GPIB connector,
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
panel GPIB connector to any one of the other devices in the test system.
a. Set the Test Set's GPIB address using the GPIB Adrs field
on page
34).
b. Set the Test Set's GPIB Controller capability using the Mode field.
•
Talk&Listen configures the Test Set to be controlled through GPIB with an
external controller. The Test Set has Active Controller capability (take control/
pass control) in this mode.
•
Control configures the Test Set to be the system controller. Use this setting
if the Test Set will be the only controller on the GPIB. Selecting Control
automatically makes the Test Set the active controller.
perform the following steps:
a. Access the PRINTER CONFIGURE screen.
b. Select one of the supported GPIB printer models using the Model field.
c. Set the Printer Port field to GPIB.
d. Set the printer address using the Printer Address field.
Chapter 1, Getting Started
Obtaining Measurement Results
(see "Addressing"
29
Advertisement
Table of Contents
