Agilent Technologies E8285A User Manual page 257

Cdma mobile station test set
Hide thumbs Also See for E8285A:
Table of Contents

Advertisement

Chapter 5, Memory Cards/Mass Storage
Using Memory Cards
The Memory Card Battery
SRAM memory cards use a lithium battery to power the card. SRAM cards
typically retain data for over 1 year at 25
replaced annually. The part number for the SRAM Card Battery is CR2025 or
Agilent Technologies part number 1420-0509.
Replacing the Battery
1. Turn the Test Set on and insert the memory card. An inserted memory card takes power
2. Hold the memory card in the slot with one hand and pull the battery holder out with your
NOTE:
The HP SRAM cards have a Battery Holder Lock switch immediately above the Write-Protect
switch. If the switch is in the locked position the battery cannot be removed. Ensure that the
Battery Holder Lock switch is in the unlocked position before trying to remove the battery.
3. Install the battery with the side marked "+" on the same side marked "+" on the battery
4. Re-insert the battery holder into the memory card.
NOTE:
The Agilent Technologies SRAM cards have a Battery Holder Lock switch immediately
above the Write-Protect switch. Ensure that the Battery Holder Lock switch is in the locked
position after installing the new battery.
5. Remove the memory card from the Test Set.
256
S:\agilent\e8285\USRGUIDE\BOOK\CHAPTERS\memcard.fb
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
from the Test Set, preventing the card's contents from being lost.
other hand. (See
figure 36
.)
holder. Avoid touching the flat sides of the battery, finger oils may contaminate battery
contacts in the memory-card.
°
C. To retain data, the battery should be

Advertisement

Table of Contents
loading

Table of Contents