Table of Contents
Advertisement
Chapter 1, Getting Started
Before Connecting a Radio
Before Connecting a Radio
NOTE:
The RF IN/OUT port should be used for all transmitter tests when the radio is connected
directly to the Test Set. (All MSUT (Mobile Station Under Test) transmitter power
measurements are made through this port). Off-the-air measurements can be made using
the highly-sensitive ANT IN port.
CAUTION:
Overpower Damage — Refer to the Test Set's front panel for maximum input power level.
Exceeding this level can cause permanent instrument damage.
Overpower Damage — Blocking the fans's rotation or operating the Test Set in
an environment that causes excessive heat may cause damage.
Important: If excessive temperatures are sensed on the power supply regulator
assembly, the Test Set's power supply will shut off. After temperature has
lowered to within normal operating range, use the POWER switch to cycle power
on. Remove RF power from the RF IN/OUT connector whenever the Test Set is
off.
20
S:\agilent\e8285\USRGUIDE\BOOK\CHAPTERS\getstart.fb
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
