Series Machine Commissioning; Loading Series Commissioning Archives - Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual

T"<<$P_TOOLP)
GOTOF _END
_NO:
MSG("No action *** Reason: programmed tool num-
ber=spindle tool number")
_END:
M17
Calling a tool change cycle with "T"
Configure the parameters shown in below table to activate a T code for calling a standard cycle:
Parameter Name
22550 TOOL_CHANGE_MODE
10717 T_NO_FCT_CYCLE[0]
The format of the standard cycle is the same with that of M codes. The programmed tool numbers will be saved into system
variable $C_T.
9

Series machine commissioning

Note
The control system constantly creates restoring points during operation. In case of data loss due to power failure or other
problems, the control system automatically restores the last autosaved system data upon startup with an alarm appearing on
the screen.
9.1

Loading series commissioning archives

You can use the series commissioning archive to commission the machines for series production. The series archive is
created during the commissioning of the prototype machine. For more information about creating a series archive, refer to
Section "Creating series archives (Page 216)".
Note
Before starting the series commissioning with the commissioning wizard, make sure MD20050, MD20070, and MD35000 are
set to defaults.
Operating sequence
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
1. Press this horizontal softkey on the main screen of wizards to call the commissioning wizard
for series machines.
2. Use either softkey to enter the window for loading the series commissioning archive.
3. Press this softkey to open the dialog for loading the series archive.
4. Enter the backup directory and select the desired archive file.
;>>> End of the standard cycle <<<
Unit Value Description
- 0 Activating tool parameters with a T code
- "TOOL" Calling the standard cycle with T code
227