Customizing Pre-Defined Labeling Strips For Keys Of The Mcp - Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED Series:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
To cut a reserved hole, proceed as follows:
A.7
Customizing pre-defined labeling strips for keys of the MCP
Note
The horizontal MCP with a reserved slot for the handwheel is designed for turning machines only. The customization of the
pre-defined labeling strips for keys is not supported by this MCP variant.
Replacing the MCP strips
The MCP strips of the turning version are already pre-assembled into the MCP. If you are using the control system of milling
version, you need to take these pre-defined labeling strips out firstly, and then insert the MCP strips of the milling version
delivered in MCP package into the MCP.
To insert the MCP strips, follow the order shown as follows with reference to the marks (M1 to M6, T1 to T6) on the strips:
Commissioning Manual
460
6FC5397-4EP10-0BA8, 07/2018
Advertisement
Table of Contents
