13.5.8
Calling the created user cycle
After you transfer all the files necessary for your own cycle to the control system, the cycle is created successfully. Then you
can call the cycle in the program editing operating area.
Proceed as follows to call the created cycle, for example, CYCLE100.
262
1.
Select the program management operating area.
2.
Select the desired part program and press this key to open it in the program editor.
Then you can see the softkey you define at the fifth horizontal softkey, for example:
3.
Press this softkey to open the lower-level menu for calling user cycles, for example:
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018