Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual page 139

MD14512 PLC interface address
Machine data - Hex
Bit 1 DB4500.DBX1020.1
Bit 2 DB4500.DBX1020.2
Bit 3 DB4500.DBX1020.3
Bit 5 DB4500.DBX1020.5
Bit 6/7 DB4500.DBX1020.6/7
14512 [21] Bit 1 DB4500.DBX1021.1
Bit 2 DB4500.DBX1021.2
Bit 3 DB4500.DBX1021.3
Bit 4 DB4500.DBX1021.4
Bit 5 DB4500.DBX1021.5
Note:
When you set MD14512, you can use the following key to open the editor for bit setting:
When the position control mode is active, do not disable the spindle by detecting the standstill speed.
1)
USER_DATA_FLOAT
MD14514 PLC interface
address
Machine data
- Float
14514[0] DB4500.DBD2000 -
14514[1] DB4500.DBD2004 -
14514[2] DB4500.DBD2008 -
14514[3] DB4500.DBD2012 -
14514[4] DB4500.DBD2016 -
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
Function
Spindle disable mode (0: disable by pressing the spindle stop key; 1: disa-
ble when detecting the standstill speed)
Activate the first additional axis (0: disable the additional axis control; 1:
enable the additional axis control)
The first additional axis as the second spindle and does not need to be
kept enabled (1: as the second spindle and does not need to be kept ena-
bled)
Define the spindle override startup value (0: the startup spindle override is
always 100%; 1: recode the spindle override value of the last machine turn
off for the next startup)
Define the spindle override shift speed
Bit 1: switch of the I/O interface (0: set I0.0-I2.7/Q0.0-Q1.7 as the standard
I/O wiring in the default PLC; 1: set I6.0-I8.7/Q4.0-Q5.7 as the standard I/O
wiring in the default PLC)
Bit 2: selection of the three-color lamp function (0: deactivate; 1: activate)
Bit 3: switch of three-color lamp flashing (0: the lamp does not flash; 1: the
lamp flashes)
Selection of the three-color lamp function (0: deactivate; 1: activate)
Switch of three-color lamp flashing (0: the lamp does not flash; 1: the lamp
flashes)
Define the spindle override, feedrate override, and rapid feedrate control
(1: spindle override and feedrate override controlled via trigger keys; rapid
feedrate is active; 0: feedrate override controlled by gray coded switch)
Define the feedrate override startup value (0: the startup feedrate override
is always 100%; 1: recode the feedrate override value of the last machine
turn off for the next startup)
Unit Range
-3.40e38 to 3.40e38
-3.40e38 to 3.40e38
-3.40e38 to 3.40e38
-3.40e38 to 3.40e38
-3.40e38 to 3.40e38
1)
Function
Tool magazine: spindle poisoning angle
Tool magazine: preparation position of Z axis for tool
change
Tool magazine: tool change position of Z axis
Tool magazine: velocity of Z axis, go to tool change
position
Tool magazine: velocity of Z axis, back to tool
change preparation position
139