Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual page 210

Configuring the spindle
● Configuring the digital spindle
● Configuring the analog spindle
210
4. Press this softkey to confirm your selection. The selected motor information then displays in
the drive list.
5. Repeat Steps 2 to 4 as above to complete the configuration of all feed axes.
1. Use the cursor keys to select the spindle MSP1 in the drive list window.
2. Press this softkey to open the spindle configuration window.
3. Use the cursor keys on the PPU to configure the digital spindle to be with/without external
spindle encoder and set the encoder resolution.
For more information about configuring a second encoder and activating the Dynamic Stiff-
ness Control (DSC) function for the digital spindle, see Section "Configuring the DSC func-
tion for the digital spindle (Page 279)".
4. Press this softkey to confirm your settings and go to the motor configuration window.
5. Use the cursor keys to select the right motor ID according to the motor rating plate.
6. Press this softkey to confirm your selection and return to the drive list window.
1. Use the cursor keys to select the spindle MSP1 in the drive list window.
2. Press this softkey to open the spindle configuration window.
3. Use the cursor keys to make the desired selections in the following window according to the
actual application, and enter relevant values where applicable:
For more information about the polarity of analog spindle, see Section "Analog spindle inter-
face - X54, spindle encoder interface - X60 (Page 88)".
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018