Establishing a direct connection
Proceed through the following steps to establish a direct connection:
+
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
1.
Connect the control system with the computer using an Ethernet cable.
2.
Select the system data operating area on the PPU.
3.
Press this key to view the extended softkeys.
4.
Set up a direct connection on the control system through the following softkey operations:
→
The following dialog box appears on the screen:
5.
Start PLC Programming Tool on your computer, and click the
open the following dialog box:
→
button in the toolbar to
43