Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual page 246
Hide thumbs
Also See for SINUMERIK 808D ADVANCED Series:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
Measuring the Z axis of the tool
246
10.
Select the offset operating area.
11.
Press the alphabetic key <Y> or proceed through the following method to open the window
for measuring the tool in the Y direction:
Move the cursor to the input field for Length Y with the cursor keys and then press this soft-
key.
12.
Enter the distance measured in Step 9 in the input field, for example, "48".
If you desire to use the relative coordinate, press this softkey.
13.
Press this softkey to confirm your input. The system calculates the offset and enters it in the
geometry input field of the currently active tool automatically.
1.
Select the machining operating area.
2.
Select a suitable override feedrate and use the handwheel to move the tool to scratch the
required workpiece edge (or the edge of the setting block, if it is used).
3.
Select the offset operating area.
4.
Press the alphabetic key <Z> or proceed through the following method to open the window
for measuring the tool in the Z direction:
Move the cursor to the input field for Length Z with the cursor keys and then press this soft-
key.
5.
Enter the distance between the tool tip and the workpiece edge in the input field, for exam-
ple, "0". (This value is the thickness of a setting block if it is used.)
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
Advertisement
Table of Contents
