Amm Communication Tool - Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED Series:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
A31117: Inversion error
signals A/B/R
Reaction: ENCODER
Acknowledgement: PULSE
INHIBIT
A31411: Encoder 1: Abso-
lute encoder signals internal
alarms
A31412: Encoder 1: Error bit
set in the serial protocol
A52900: Failure during data
copying
A.9
AMM communication tool
With the communication tool Access MyMachine (AMM), you can establish an Ethernet connection and realize data transfer
between the control system and a computer. This tool is available in the Toolbox and is supported by Windows Vista/Win 7.
Ethernet connections
The following Ethernet connections are possible between the control system and the AMM tool on the computer:
● Direct connection: connecting the control system directly to a computer
● Network connection: integrating the control system into an existing Ethernet network
For more information about connecting the AMM tool, see Section "Connecting with AMM (Page 47)".
After an active Ethernet connection is established, the AMM tool provides the possibility of data exchange between the
control system and a computer, as well as remote control of the HMI from the computer. For more information about the tool
functionality, see the Online Help of the tool.
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
For a square-wave encoder (bipolar, dou-
ble ended) signals A*, B* and R* are not
inverted with respect to signals A, B and
R.
The absolute encoder fault word includes
alarm bits that have been set.
The encoder sends a set error bit via the
serial protocol.
Copying is halted.
•
The SD card was plugged out.
•
The drive is not in the stop state.
•
Check the encoder/cable.
•
Does the encoder supply signals and the
•
associated inverted signals?
Check the encoder cable connection, and
•
make sure the encoder cables are routed in
compliance with EMC.
Check the motor temperature.
•
Replace the encoder/motor.
•
Carry out a POWER ON (power off/on) for
•
all components.
Check that the encoder cables are routed
•
in compliance with EMC.
Check the plug connections.
•
Replace the encoder.
•
Re-plug in the SD card.
•
Make sure the drive is in the stop state.
•
475
Advertisement
Table of Contents
