Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual page 214

If the axis is referenced, a symbol
Relevant machine data
No. Name
20700 REFP_NC_START_LOCK
34010 REFP_CAM_DIR_IS_MINUS
34020 REFP_VELO_SEARCH_CAM
34040[0] REFP_VELO_SEARCH_MARK
ER
34050[0] REFP_SEARCH_MARKER_R
EVERSE
34060[0] REFP_MAX_MARKER_DIST
34070 REFP_VELO_POS
34080[0] REFP_MOVE_DIST
34090[0] REFP_MOVE_DIST_CORR
34092[0] REFP_CAM_SHIFT
34093[0] REFP_CAM_MARKER_DIST
34100[0] REFP_SET_POS
34200[0] ENC_REFP_MODE
34210[0] ENC_REFP_STATE
34220[0] ENC_ABS_TURNS_MODULO
34230[0] ENC_SERIAL_NUMBER
Note
You must set the length of the reference cam based on the velocity set by MD34020. An axis can stop above the cam after it
approaches the cam at the velocity set by MD34020 and then decelerates to "0".
214
appears next to the axis identifier, for example:
Unit Range
- -
- -
mm/min -
mm/min -
- -
mm -
mm/min -
mm -
mm -
mm -
mm -
mm -
- 0 to 8
- 0 to 3
- 1 to 100000
- -
Description
NC start disable without reference point
Direction for approaching the reference point:
0: +
•
1: -
•
Velocity for searching for the reference cam
Velocity for searching for the zero mark
Direction for searching for the zero mark:
0: +
•
1: -
•
Checking the maximum distance from the refer-
ence cam
Positioning velocity for approaching the reference
point
Reference point distance (with marker)
Correction of reference point distance
Shift of the reference cam
Distance between the reference cam and the first
zero mark
Reference point position for incremental system
Referencing mode
Adjustment status of the absolute encoder
Modulo range for the rotary absolute encoder
Encoder serial number
6FC5397-4EP10-0BA8, 07/2018
Commissioning Manual