5
Initial system setup
5.1
System startup menu
The control system carries out a normal startup by default after power-on. When necessary, you can press this
key on the PPU once the message "Press the SELECT key to enter set-up menu" appears while the system
boots to select other startup options via the following menu:
①
The system carries out a normal startup.
②
The system loads the user data saved through the following operations from the system CF card:
③
The system loads the default NC data and settings, and deletes the retentive data on the PLC.
④
The PLC is stopped.
⑤
The system resets the PLC and loads the default PLC program.
⑥
The system loads the default HMI settings.
⑦
The system installs an update on the system CF card from the USB flash drive.
Note: The above menu options
120
+
→
③
⑥
to
are only visible if the manufacturer password is set before last power-off.
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018