Selecting A Target System - Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED Series:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
6.7.4
Selecting a target system
In PLC Programming Tool, you can select the PLC type as preset. In the instruction tree, the instructions that cannot be
used for the target system are marked with a red × (for example,
After the PLC type is preset, an error check of the program takes place when the program is written.
Operating sequence
1.
2.
3.
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
Start PLC Programming Tool on your PC.
Choose from the main screen menu as follows:
Then the following dialog box opens:
You can alternatively call this dialog by right-clicking the project name in the project tree and
choosing from the shortcut menu.
Select a desired target system from the drop-down list in the dialog box.
If an active communication has been established between PLC Programming Tool and the control
system, you can alternatively click the following button to read the information directly from the
target system:
).
185
Advertisement
Table of Contents
