5.3.12 Pulseblanking Enable/Disable Pulse Blanking; Frequency Switch; Pulse Blanking Switch - Novatel EuroPak-15a User Manual

Chapter 5

5.3.12 PULSEBLANKING Enable/Disable Pulse Blanking

The PULSEBLANKING command should only be used by advanced users.
This command enables or disables digital pulse blanking. By default, the digital pulse blanking is enabled. The
sensitivity of the digital pulse blanking may be adjusted using the switch field.
Syntax:
PULSEBLANKING
Field
Field
Name
1 header
2 frequency
3 switch
Examples:
PULSEBLANKING L1 5
62
FREQUENCY
Valid Values
This field contains the Abbreviated ASCII command name. See
Section 4.1 on Page 31.
Pulse blanking frequency. See
L1 or L5
Table 30 below.
0-127 Pulse blanking switch using
thresholds. See Table 31 below.
Table 30: Frequency Switch
ASCII Description
L1 GPS L1 and Galileo L1 frequency
L5 GPS L5 and Galileo E5a frequency
Table 31: Pulse Blanking Switch
ASCII
0
1-127
SWITCH
Description
Description
Disable pulse blanking
Enable pulse blanking
EuroPak-15a Receiver User Manual Rev 5
Commands
Message ID: 519
Binary Binary
Format
Bytes
H 0
Enum
4 H
Ulong 4 H+4
Offset