Reading The Position Correction Table From The Servopack - YASKAWA Sigma-7 Series Product Manual

Reading the Position Correction Table from the SERVO-
PACK
Use the following procedure to read the Position Correction Table from the SERVOPACK.
1.
Click All Parameters in the Read from Servo Group.
Parameter will be used in the dialog box, but parameters are not read from the SERVO-
Information
PACK.
The Position Correction Table is read from the SERVOPACK.
2.
Click the Yes Button.
This concludes the procedure to read the Position Correction Table from the SERVOPACK.
3.4 Position Correction Table Settings
3.4.3 Setting Method with the SigmaWin+
3
3-15